You should spend about 20 minutes on this task. The diagram below shows the stages and equipment used in the process of making matches. Summarize the information by selecting and reporting the main features, and make comparisons where relevant. Write at least 150 words. WRITING TASK 1 BC IELTS Ac Writing PT 13 WRITING TASK 1 You should spend about 20 minutes on this task. The diagram below shows the stages and equipment used in the process of making matches. Summarise the information by selecting and reporting the main features, and make com
The diagram above illustrates the process of making matches. Overall, the log is peeled, prepared and dried before proceeding to the next steps. Then, the sticks are stored and mix with a number of chemicals. Before the matches are done prepared, the matches are dried at the drying area.
First of all, the log is rotated at the peeler. The sharp blade is used to peel the outer surface of the log as it rotates, which is known as veneer. Next, the veneer is proceeded to the chopper. The chopper is used to chop the veneer into small, short and thin sticks. The sticks are now dipped into ammonium phosphate tank and dried in the dryer as the dryer rotates.
In the next phase, the sticks are dropped into the hopper and is blown to the large storage area to be stored by using a high power blower. Subsequently, the sticks are inserted into a funnel- shaped device to be inserted on the long and continuous perforated steel belt. By using the perforated steel belt, the sticks are then dipped into several tanks filled with chemicals, which is paraffin wax, followed by based chemicals and tip chemicals before the sticks are dried in the drying area, which loops up and down. Finally, the sticks are packaged into a box in packaging area and the matches are ready to be used.
The diagram above illustrates the process of making
matches
.
Overall
, the log
is peeled
, prepared and
dried
before
proceeding to the
next
steps. Then, the
sticks
are stored
and mix with a number of
chemicals
.
Before
the
matches
are done
prepared, the
matches
are
dried
at the drying area.
First of all
, the log
is rotated
at the peeler. The sharp blade is
used
to peel the outer surface of the log as it rotates, which
is known
as veneer.
Next
, the veneer
is proceeded
to the chopper. The chopper is
used
to chop the veneer into
small
, short and thin
sticks
. The
sticks
are
now
dipped into ammonium phosphate tank and
dried
in the dryer as the dryer rotates.
In the
next
phase, the
sticks
are dropped
into the hopper and
is blown
to the large storage area to
be stored
by using a high power blower.
Subsequently
, the
sticks
are inserted
into a funnel- shaped device to
be inserted
on the long and continuous perforated steel belt. By using the perforated steel belt, the
sticks
are then dipped into several tanks filled with
chemicals
, which is paraffin wax, followed by based
chemicals
and tip
chemicals
before
the
sticks
are
dried
in the drying area, which loops up and down.
Finally
, the
sticks
are packaged
into a box in packaging area and the
matches
are ready to be
used
.