The diagram shows how to change a flat tyre. It is a mechanical process that involves 14 steps.
The first part of the process is that there is a lot of glass debris under the road which causes the tires to go flat. Then, park the car in a suitable place to pull over the car, turn on the hazard lights and prepare the spare tire, jack, and wrench. The following step is to remove the hub car and loosen the wheel nuts and make sure to not remove it at that time. After that, carefully place the jack under the car near the flat tire about 15cms from the surface of the road.
The other part goes into change the tyre. Before use, the spare tire, make sure to remove the lug nuts. Then remove the flat tyre, push the new onto the place and remember do not to tighten all the way. Before tightening each one halfway and continue until all are tight, use the jack again to low the car. Finally, remember to do not to leave anything on the side of the road.
The diagram
shows
how to
change
a
flat
tyre
. It is a mechanical process that involves 14 steps.
The
first
part of the process is that there is
a lot of
glass debris under the road which causes the
tires
to go
flat
. Then, park the
car
in a suitable place to pull over the
car
, turn on the hazard lights and prepare the spare
tire
, jack, and wrench. The following step is to
remove
the hub
car
and loosen the wheel nuts and
make
sure to not
remove
it at that time. After that,
carefully
place the jack under the
car
near the
flat
tire
about 15cms from the surface of the road.
The other part goes into
change
the
tyre
.
Before
use
, the spare
tire
,
make
sure to
remove
the lug nuts. Then
remove
the
flat
tyre
, push the new onto the place and remember do not to tighten all the way.
Before
tightening each one halfway and continue until all are tight,
use
the jack again to low the
car
.
Finally
, remember to do not to
leave
anything on the side of the road.